guides:payload_labels
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| guides:payload_labels [2013/07/21 10:55] – created g0tdj | guides:payload_labels [2013/12/11 09:50] (current) – rharrison1971 | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| It is specific for the UK Amateur Radio & HAB community but Steve has offered to regionalise it by request. Please send an e-mail to steve (at) g0tdj.com with your requirements. | It is specific for the UK Amateur Radio & HAB community but Steve has offered to regionalise it by request. Please send an e-mail to steve (at) g0tdj.com with your requirements. | ||
| + | |||
| + | {{: | ||
| **To use the label**, first print either on to stiff card if possible or paper. Very lightly score along the fold line with a knife (do not cut through). Then, with a safety ruler, cut along the trim lines opposing each other. Do not trim to the edge of the card/paper. Once you have cut the label out, fold along the middle and add your information in the relevant fields. Then, if you are using card, use a hole punch to punch a hole where indicated. Thread your payload line through this before launch. If you are using paper, laminate the folded label before punching the hole. | **To use the label**, first print either on to stiff card if possible or paper. Very lightly score along the fold line with a knife (do not cut through). Then, with a safety ruler, cut along the trim lines opposing each other. Do not trim to the edge of the card/paper. Once you have cut the label out, fold along the middle and add your information in the relevant fields. Then, if you are using card, use a hole punch to punch a hole where indicated. Thread your payload line through this before launch. If you are using paper, laminate the folded label before punching the hole. | ||
| + | --- | ||
| + | |||
| + | Robert Harrison Adds | ||
| + | |||
| + | Payload is harmless unless it hits you on the head :-) | ||
guides/payload_labels.1374404132.txt.gz · Last modified: 2013/07/21 10:55 by g0tdj