projects:ukhas_glider_project:components
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:ukhas_glider_project:components [2007/11/08 17:34] – Thermopile amplifier for zagi laurenceb | projects:ukhas_glider_project:components [2008/07/19 23:33] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 9: | Line 9: | ||
====== Thermopile Pitch and Roll sensor and amplifier board ====== | ====== Thermopile Pitch and Roll sensor and amplifier board ====== | ||
+ | |||
+ | |||
+ | == V 2.0 (with a2d convertor and spi interface) == | ||
+ | |||
+ | PCB: | ||
+ | |||
+ | {{projects: | ||
+ | {{projects: | ||
+ | |||
+ | | ||
+ | |||
+ | |||
+ | {{projects: | ||
+ | |||
+ | | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | == V 1.0 (analogue) == | ||
+ | |||
A milled enclosure has now been made for smaller Nicera sensors obtained from Chartland electronics | A milled enclosure has now been made for smaller Nicera sensors obtained from Chartland electronics | ||
+ | {{projects: | ||
{{projects: | {{projects: | ||
{{projects: | {{projects: | ||
- | The plan is to fit a SMD amplifier board inside the enclosure. The design is now complete and will probably be sent to batchpcb.com | + | The plan is to fit a SMD amplifier board inside the enclosure. The design is now complete and has been sent to batchpcb.com |
+ | {{projects: | ||
{{projects: | {{projects: | ||
{{projects: | {{projects: |
projects/ukhas_glider_project/components.1194543243.txt.gz · Last modified: 2008/07/19 23:32 (external edit)