UKHAS Wiki

UK High Altitude Society

User Tools

Site Tools


projects:ukhas_glider_project:components

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
projects:ukhas_glider_project:components [2007/09/17 20:19] laurencebprojects:ukhas_glider_project:components [2008/07/19 23:33] (current) – external edit 127.0.0.1
Line 6: Line 6:
  
 {{projects:ukhas_glider_project:p7190024.jpg?700|}} {{projects:ukhas_glider_project:p7190024.jpg?700|}}
 +
  
 ====== Thermopile Pitch and Roll sensor and amplifier board ====== ====== Thermopile Pitch and Roll sensor and amplifier board ======
 +
 +
 +== V 2.0 (with a2d convertor and spi interface) ==
 +
 + PCB:
 +
 +{{projects:ukhas_glider_project:thermoboard2.2pcb.png?650|}}
 +{{projects:ukhas_glider_project:thermoboard2.3pcb.png?650|}}
 +
 + Schematic (using AD7923):
 +
 +
 +{{projects:ukhas_glider_project:thermoboard2.0.png?700|}}
 +
 + fitting the pcb into a 20mm square is proving hard, but hopefully it will prove possible, and can be sent off to batchpcb soon.
 +
    
  
-A milled enclosure has now been made for smaller Nicera sensors obtained from Chartland electronics+ 
 + 
 + 
 + 
 +== V 1.0 (analogue) == 
    
- {{projects:ukhas_glider_project:box4.jpg|}} + A milled enclosure has now been made for smaller Nicera sensors obtained from Chartland electronics 
- {{projects:ukhas_glider_project:box1.jpg|}}+ 
 +{{projects:ukhas_glider_project:explode2.jpg?600|}} 
 +{{projects:ukhas_glider_project:box4.jpg|}} 
 +{{projects:ukhas_glider_project:box1.jpg|}} 
 + 
 + The plan is to fit a SMD amplifier board inside the enclosure. The design is now complete and has been sent to batchpcb.com for production :-)  
 + 
 +{{projects:ukhas_glider_project:schematic.jpg?800|}} 
 +{{projects:ukhas_glider_project:design.png?600|}} 
 +{{projects:ukhas_glider_project:schematic.png?600|}}
    
  
- The thermopile sensor unit has been epoxied to a pice of balsa that will for the back of the parachute release mechanism on the glider.+ The prototype thermopile sensor unit has been epoxied to a pice of balsa that will for the back of the parachute release mechanism on the glider.
  
  
projects/ukhas_glider_project/components.1190060359.txt.gz · Last modified: 2008/07/19 23:32 (external edit)

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki