projects:ukhas_glider_project:components
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:ukhas_glider_project:components [2007/09/17 20:18] – laurenceb | projects:ukhas_glider_project:components [2008/07/19 23:33] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 6: | Line 6: | ||
{{projects: | {{projects: | ||
+ | |||
====== Thermopile Pitch and Roll sensor and amplifier board ====== | ====== Thermopile Pitch and Roll sensor and amplifier board ====== | ||
- | A milled enclosure has now been made for smaller Nicera sensors obtained from Chartland electronics | + | |
+ | |||
+ | == V 2.0 (with a2d convertor and spi interface) == | ||
+ | |||
+ | | ||
+ | |||
+ | {{projects: | ||
+ | {{projects: | ||
+ | |||
+ | | ||
+ | |||
+ | |||
+ | {{projects: | ||
+ | |||
+ | | ||
- | | + | |
- | {{projects: | + | |
+ | |||
+ | |||
+ | |||
+ | == V 1.0 (analogue) == | ||
- | The thermopile sensor unit has been epoxied to a pice of balsa that will for the back of the parachute release mechanism on the glider. | + | A milled enclosure has now been made for smaller Nicera sensors obtained from Chartland electronics |
+ | |||
+ | {{projects: | ||
+ | {{projects: | ||
+ | {{projects: | ||
+ | |||
+ | The plan is to fit a SMD amplifier board inside the enclosure. The design is now complete and has been sent to batchpcb.com for production :-) | ||
+ | |||
+ | {{projects: | ||
+ | {{projects: | ||
+ | {{projects: | ||
+ | |||
+ | |||
+ | The prototype | ||
{{projects: | {{projects: | ||
Line 19: | Line 54: | ||
=== Test system === | === Test system === | ||
+ | |||
{{projects: | {{projects: | ||
Line 30: | Line 66: | ||
====== Parachute Deployment System ====== | ====== Parachute Deployment System ====== | ||
+ | |||
{{: | {{: | ||
{{: | {{: |
projects/ukhas_glider_project/components.1190060291.txt.gz · Last modified: 2008/07/19 23:32 (external edit)