projects:earthshine:gps:testing
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
projects:earthshine:gps:testing [2010/03/23 22:52] – created zooto68 | projects:earthshine:gps:testing [2010/04/02 15:32] (current) – zooto68 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | **TESTING** | + | ====== INITIAL TESTS OF THE GPS UNIT ====== |
+ | |||
+ | |||
+ | After acquiring the [[http:// | ||
+ | |||
+ | |||
+ | |||
+ | **The GPS Module soldered (badly - my soldering iron tip was knackered and didn't get hot enough) up to some wires for testing on a breadboard with an FTDI Cable:** | ||
+ | |||
+ | {{http:// | ||
+ | |||
+ | |||
+ | **The Earthshine1 Research 7 Development Centre (OK so it's my kitchen table). Ignore the RoboRaptor, you didn't see it:** | ||
+ | |||
+ | {{http:// | ||
+ | |||
+ | |||
+ | **The u-Center software showing valid NMEA data from the GPS Module:** | ||
+ | |||
+ | {{http:// | ||
+ | |||
- | After acquiring the Falcom FSA03 GPS Unit (now available at Earthshine Design) I decided to do some basic testing to ensure the units work and communicate over serial. After reading the datasheets and getting some advice from Terry (Project Horus) I soldered some wires onto a unit for testing purposes to hook it up to a 3.3v supply from a bench PSU and an FTDI cable to communicate with the u-Center software provided by uBlox. | ||
projects/earthshine/gps/testing.1269384751.txt.gz · Last modified: 2010/03/23 22:52 by zooto68