Differences

This shows you the differences between two versions of the page.

--- guides:fill_tube [2012/03/18 20:02] – rocketboy
+++ guides:fill_tube [2013/08/10 13:40] (current) – Added valve connection chrisstubbs
@@ Line 1: / Line 1: @@
 ====== Fill Tube ======
-This is a minimal filler tube - its made from 40mm PVC waste water tubing about 75mm long.  A shallow grove is cut all the way round.
+This is a minimal filler tube - its made from 40mm PVC waste water tubing about 75mm long.  A shallow grove is cut all the way round. The loop of nylon cord allows weights to be tied on.
 {{:guides:filler1.jpg?200|}}
+Shot showing internal spacer - about 15mm thick super-glued to both the outer (PVC Waste) and inner (clear braided flexible fill) tubes.
-Shot showing internal spacer - about 15mm thick super-glued to both the outer and inner tubes.
 {{:guides:filler2.jpg?200|}}
 Balloon Neck pushed over the filler tube - Totex balloons are a tight fit.
 {{:guides:filler3.jpg?200|}}
 And secured with a cable tie that sits over the grove.
 {{:guides:filler4.jpg?200|}}
 For Hwoyee balloons fold the neck over and tie.
-{{:guides:filler5.jpg?200|}}
+{{:guides:filler5.jpg?200|}}
 The grove and the cable tie ensure the neck is well secured.
 {{:guides:filler6.jpg?200|}}
+Depending on the diameter of hose used you should be able to attach it to the "Balloon inflation valve" BOC/airproducts provide by heating the pipe by a hairdyer and pushing it as far as it will go over the valve. Wrap with a little insulating tape after for a better seal.
+{{:guides:9352720505_2fe92246e1.jpg?200|}}