Differences

This shows you the differences between two versions of the page.

--- ideas:flight_support [2006/11/21 22:59] – rocketboy
+++ ideas:flight_support [2013/05/07 07:55] (current) – [Radar Reflector] rocketboy
@@ Line 9: / Line 9: @@
 {{:ideas:corner.jpg|:ideas:corner.jpg}}
+FAR101 says "the reflector will present an echo to surface radar operating in the 200 MHz to 2700 MHz frequency range".
 Size - commercial radiosonde radar refelctors are about 50cm tip to tip.
@@ Line 27: / Line 29: @@
 The igniter needs about 2amps @ 3Volts for just a few milli seconds to fire - it can even be fired from a charged 4700uF capacitor.
-{{:ideas:cct3.gif|:ideas:cct3.gif}}
+{{ideas:cct0.gif|}}
+The ignitor on the right hand side of the circuit can be replaced by a small 6V bulb for testing - the bulb will light briefly when fired. Once you are happy with the circuit try an igniter.
-The bulb on the right hand side of the circuit is for initial testing - choose somthing that will draw about 1 - 2 amps from the supply - e.g. for 6V a 6W bulb. Connect it between the supply line and the darlington collector (marked c). Once you are happy with the circuit try an igniter.
+[''adeptium/STARS Project'': Not happy about the use of a wet cap for near-space use, but Farnell supplies an AVX 3300uF tantalum, 4-10V operating range, rated to -55C with no loss of capacity.  I'm going to try with one or two of these.]