Differences

This shows you the differences between two versions of the page.

--- guides:ublox8 [2016/08/06 22:45] – [uBlox NEO-6Q / uBlox MAX-6Q] rharrison1971
+++ guides:ublox8 [2016/09/08 14:47] (current) – upu
@@ Line 16: / Line 16: @@
 The chip is shielded though normal precautions with regards to ESD should be observed. Data sheet is available [[https://www.u-blox.com/sites/default/files/MAX-8_DataSheet_(UBX-16000093).pdf|here]].
-**WARNING : uBLOX 6 Chips are rated at 3.3v so you can't just plug this into an 5V Arduino board or a PC serial connection as these run at 5V.**
+**WARNING : uBLOX 8 Chips are rated at 3.3v so you can't just plug this into an 5V Arduino board or a PC serial connection as these run at 5V.**
-You can purchase a seperate level convertor from [[http://www.sparkfun.com/products/8745|Sparkfun]] or use a breakout with the integral level convertor available from [[http://ava.upuaut.net/store|HAB Supplies]].
+You can purchase a seperate level converter from [[http://www.sparkfun.com/products/8745|Sparkfun]] or use a breakout with the integral level converter available from [[https://store.uputronics.com|Uputronics]].
-The MAX-6 Chip, Sarantel antenna and populated breakout boards can be purchased from [[http://ava.upuaut.net/store|HAB Supplies]].
+The MAX-8 Chip, Sarantel antenna and populated breakout boards can be purchased from [[https://store.uputronics.com|Uputronics]].
 ===== Hardware =====
@@ Line 27: / Line 27: @@
-If you want to integrate the units into your own design both modules and antennas are in [[https://www.dropbox.com/s/qytveix714ocw11/Ava.lbr|Ava.lbr]].
+If you want to integrate the units into your own design both modules and antennas are in [[https://github.com/Upuaut/Eagle-Libraries|Ava.lbr]].
 ===== Software Serial Configuration Example =====
-All commands the same as the uBLOX5 documented by Jcoxon in the [[guides:falcom_fsa03|Falcom FSA03]] guide.The following code has been updated to reflect the changes to Software Serial in Arduino. The uBLOX 6 modules do seem particularly sensitive to timing issues on Software Serial therefore its recommended you use the hardware UARTS on the Arduino for the GPS. Tested in Arduino 1.0.1 :
+All commands the same as the uBLOX5 documented by Jcoxon in the [[guides:falcom_fsa03|Falcom FSA03]] guide.The following code has been updated to reflect the changes to Software Serial in Arduino. The uBLOX 8 modules do seem particularly sensitive to timing issues on Software Serial therefore its recommended you use the hardware UARTS on the Arduino for the GPS. Tested in Arduino 1.0.1 :
 <code c>
@@ Line 207: / Line 207: @@
 x Arduino Board\\
-x ublox MAX6 Breakout (Level Converted if using 5V Arduino)(UB6)\\
+x ublox MAX8 Breakout (Level Converted if using 5V Arduino)(UB6)\\
 x UM232 Serial UART Development Module or equivalent.\\