Differences

This shows you the differences between two versions of the page.

--- guides:ublox6 [2013/06/23 15:02] – 'echo's' -> echoes willdude123
+++ guides:ublox6 [2016/09/08 14:52] (current) – Up upu
@@ Line 7: / Line 7: @@
 **WARNING : uBLOX 6 Chips are rated at 3.3v so you can't just plug this into an 5V Arduino board or a PC serial connection as these run at 5V.**
-You can purchase a seperate level convertor from [[http://www.sparkfun.com/products/8745|Sparkfun]] or use a breakout with the integral level convertor available from [[http://ava.upuaut.net/store|HAB Supplies]].
+You can purchase a seperate level converter from [[http://www.sparkfun.com/products/8745|Sparkfun]] or use a breakout with the integral level converter available from [[https://store.uputronics.com|Uputronics]].
-The MAX-6 Chip, Sarantel antenna and populated breakout boards can be purchased from [[http://ava.upuaut.net/store|HAB Supplies]].
+The MAX-6 Chip, Sarantel antenna and populated breakout boards can be purchased from [[https://store.uputronics.com|Uputronics]].
 ===== Hardware =====
@@ Line 201: / Line 201: @@
 Connect UB6 5V on the board to 5V on the Arduino\\
 Connect UB6 GND on the board to GND on the Arduino\\
-Connect UB6 TX on the board to pin 1 TX\\
+Connect UB6 RX on the board to pin 1 TX\\
-Connect UB6 RX on the board to pin 0 RX\\
+Connect UB6 TX on the board to pin 0 RX\\
 Connect UM232R pin DB0 to pin 4 on the Arduino\\
 Connect UM232R pin DB1 to pin 5 on the Arduino\\